To do a final test, do the following:

  • Unplug the battery and the solar panel from the control unit
  • Unplug the USB cable from CropVIEW unit
  • Connect the cable from control unit to the CropVIEW unit – make sure it is connected in the right way – as shown on the picture below


  • Connect the battery to the control unit
  • Connect the solar panel to the control unit
  • After approximately one or one and a half hour you should see the photos on the web site (it depends on the quality of the internet connection)
  • Unplug the battery and solar panel for transport or storage
  • Your CropVIEW device is ready for field installation