Loading...
 

1. Unplug control unit from CropVIEW unit

Connectcwtopc

2. Connect CropVIEW unit to your PC with USB cable to mini-USB
Use the mini USB port in the lower left corner of the board.

3. Place the jumper in position J1. If you have access to the internet, USB drivers will be installed automatically.

Attention:
The CropVIEW device has two mini-USB ports. Use the one labeled as “MAIN-USB” (the other one is only for service purposes).

USB driver

The PC should recognize automatically the CropVIEW device once you connect it via the USB and it will install
the needed driver itself with no further intervention. In case of problems or in the case that your first installation
is offline you can previously download and install the driver from the following link:

http://www.st.com/content/st_com/en/products/development-tools/software-development-tools/stm32-software- development-tools/stm32-utilities/stsw-stm32102.html